Capillaries are also called breathing tubes, capillary vessels, stainless steel tubes, ventilation tubes, etc.

At present, the single leaf area of Ginghongxin hollow shutter glass on the market is more than 0.5 square meters, all of which are equipped with capillaries.

Generally, magnetic control hollow shutter glass is processed in different regions and seasons, and the air pressure is different inside and outside. The products processed in Suzhou are transported to the three northeastern provinces

The empty layer is prone to internal absorption. Including the products produced and installed in the same factory in the same area in summer will also produce internal absorption in winter. What’s the reason? Because in the weather

When it is hot, the internal pressure is the same as the external pressure, but in winter, the external pressure is greater than the internal pressure, resulting in glass deformation. When the glass deformation exceeds a certain amount, the width of the hollow layer is narrower than the width of the blade, it cannot be used

It’s up. At this time, the capillaries are needed to connect the outside and the inside. When internal suction occurs, the hollow layer is changed back to the original state by blowing air through the continuous capillaries, so that the air pressure is reduced

You won’t inhale it.

General factory technicians believe that the  magnetic control shutter glass can be filled with argon to ensure no internal absorption, but Ginghongxin believes that filling with argon can ensure that the shutter glass will not leak for one to two years

No internal suction is allowed, but if you need to ensure no internal suction for five or even ten years like Ginghongxin, you must install capillaries in addition to filling argon, so as to ensure high quality.

Capillaries - raw materials are not stainless steel, with an outer diameter of 1mm and an inner diameter of 0.5mm. It is generally produced by special stainless steel factory, with a length of 150mm. It needs to be exposed outside the glass during installation,

It can be stuck in the guide rail of the magnetic controller, which does not affect the appearance and is convenient to use.